![]() ![]() Interface Cable Pinout Diagram & Configuration Instructionsġ) Install KCT-19 Accessory Cable Assembly, in accordance with service manual instructions.Ģ) Cut Pin 1 wire (BRN) on KCT-19 8-pin sub-connector D (CN4), splice an extension wire to theĪccessory/peripheral side, and solder to CN1 pin 11 (designated AFO) on TX/RX PCB. KENWOOD TK-圆0 G-Series CPI TTP1 Tone-Termination Panel If tone, here's a document-you also didn't say if they were 760G or just 760.at any rate, this sheet ought to get you started in the right direction. ![]() You didn't mention whether you plan to use tone or DC termination, or an IRim box. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |